Allied Telesis AR Series Hardware Reference Manual page 35

Hardware Reference
Figure 15: Front and rear panels of the AT-AR410 Series router.
AR410
Branch Office Router
POWER
POWER POWER
AC Power Inlet
AC Power Switch
C613-03031-01 REV E
The MAC slot can accommodate any one of the following MACs:
• AT-AR010 EMAC, Encryption MAC.
• AT-AR011 ECMAC, Compression/Encryption MAC
• AT-AR011 V2 ECMAC, Compression/Encryption MAC.
• AT-AR012 CMAC, Compression MAC.
MACs should only be installed by authorised service personnel. Unauthorised
opening of the router lid may cause danger of injury from electric shock, damage
to the router, and invalidation of the product warranty.
Front and rear panels of the AT-AR410 router with a PIC installed are shown in
Figure 15 on page 35.
STATUS PIC BAY0
SYSTEM ENABLED
ETH0 10BASE-T/100BASE-TX SWITCH PORTS
4
X PC
= HUB
10/100 Switch Ports
ETH 0
LEDs and what they mean
Functions of the AR410's LEDs are shown in Table 16 on page 36. Additional
LEDs may be present if a PIC is installed. Functions of PIC LEDs are described
in the Port Interface Card Hardware Reference.
10BASE-T/100BASE-TX SWITCH PORTS
FULL DUP
LINK/ACT
100M
1 2 3 4
PIC BAY0
CONSOLE RS-232
3X 2X 1X
ASYN0
Console Port
ETH0
FULL DUP
LINK/ACT
100M
SYN
Tx
Rx
PIC Bay (with optional
AT-AR023 SYN PIC)
35