Allied Telesis AR Series Hardware Reference Manual page 23

Hardware Reference
Figure 7: Front and rear panels of the AT-AR370(U) router.
Front Panel Model name
AR370
Access Router
Rear Panel
AR370
ISDN-U BRI 0
BRI-U ISDN Port
C613-03031-01 REV E
Table 7: Functions of the front panel LEDs on the AT-AR370(S) router.
LED Function
LAN Link Lit when the Ethernet interface is connected to a device (e.g., a hub),
which is generating link pulses. This LED is normally lit.
LAN Txd Lit when data is being transmitted over the Ethernet interface.
LAN Coll (yellow) Lit when a collision is detected on the Ethernet interface.
LAN Rxd Lit when data is being received on the Ethernet interface.
WAN Syn Lit when data is being transmitted or received over the synchronous
interface.
WAN ISDN Lit when data is being transmitted or received over the ISDN interface.
WAN Active Lit when the BRI has successfully completed the exchange of INFO 1 and
INFO 2 signals, and INFO 3 and INFO 4 signals are present on the link.
This means that the ISDN interface is correctly connected to a working
NT device.
System (red) This LED is not normally lit. It is used to signal various system conditions
(e.g., when the processor executes the reboot sequence). Generally it
signals a possible fault condition, but it will light briefly during power-
up and operator initiated reboot.
Run Lit when the internal processor is executing code. If the processor stops
for any reason (a fault condition), then the LED will not be lit.
Power Lit when power is supplied and the router is switched on.
PORT 1 (RS232)
ETHERNET 0
PORT 0 (RS232)
MDX
HUB
Ethernet port
Asynchronous
ports
10BASE-T
SYNCHRONOUS 0
CONFIG
1 2 3 4
PC
DIP Synchronous port
switch
WAN
LEDs
100–240 VAC, 50–60Hz, 300mA.
DISCONNECT MAINS SUPPLY BEFORE REMOVING LID
NO USER SERVICEABLE PARTS
Power inlet
23
370UFRP