Adjusting The Motion Control Neutral-Lock Pivot; Hydraulic System Maintenance; Hydraulic System Safety; Servicing The Hydraulic System - Toro Z Master 6000 Professional Series Operator's Manual

Adjusting the Motion
Control Neutral-Lock Pivot
The flanged nut can be adjusted to obtain a more
desired motion-control lever resistance when moving
it to the N -
EUTRAL LOCK
adjustment options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired
feel.
Note:
For more resistance, tighten the flanged
nut.
Note:
For less resistance, loosen the flanged
nut
3. Tighten the jam nut.
Figure 91
1. Flanged nut
position. See Figure 91
2. Jam nut
Hydraulic System
Maintenance

Hydraulic System Safety

for
•
Ensure that all hydraulic-fluid hoses and
lines are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to the hydraulic system.
•
Keep your body and hands away from pinhole
leaks or nozzles that eject high-pressure
hydraulic fluid.
•
Use cardboard or paper to find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
•
Seek immediate medical attention if fluid
is injected into skin. Injected fluid must be
surgically removed within a few hours by a
doctor.
Servicing the Hydraulic
System
Hydraulic-Fluid Type: Toro
hydraulic fluid or Mobil
g008621
Important:
could damage the hydraulic system.
Each Hydraulic System Fluid Capacity: 1.5 L (52
oz) per side with filter change
Checking the Hydraulic Fluid
Service Interval: Every 50 hours—Check the
1. Position the machine on a level surface.
2. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Allow the engine and the hydraulic system to
cool for 10 minutes.
Note:
when the oil is checked and the unit is hot.
5. Move the seat forward.
6. Clean the area around the dipsticks of
hydraulic-system reservoirs
7. Remove 1 dipstick from the hydraulic reservoir
(Figure
62
® HYPR-OIL
® 1 15W-50.
Use the specified fluid. Other fluids
hydraulic-fluid level.
The oil level on the dipstick is incorrect
(Figure
92).
™ 500
-
EUTRAL LOCK
92).