Toro Z Master 6000 Professional Series Operator's Manual page 66

1. 7.6 cm (3 inch) at position
A is correct
2. 8.3 cm (3-1/4 inch) at
position B is correct
10. Fine-tune the adjustment nut on the front deck
lift assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease, turn
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, the
single-point adjustment can be utilized to gain
more adjustment.
Figure 96
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure 97).
g009196
1. Adjustment nut
2. Jam nut
11. To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure 98).
1. Bolts at the bottom of the height-of-cut plate
12. If the deck is too low, tighten the
single-point-adjustment bolt by rotating it
clockwise. If the deck is too high, loosen
the single-point-adjustment bolt by rotating it
counterclockwise
66
Figure 97
3. Rear deck adjustment
4. Front deck adjustment
Figure 98
(Figure 99).
g027344
g027345