Removing The Sheet-Metal Guard; Lubrication; Adding Light Oil Or Spray Lubrication - Toro Z Master 6000 Professional Series Operator's Manual

Removing the Sheet-Metal
Guard
Loosen the 2 front bolts and remove the sheet-metal
guard to access the mower belts and spindles
(Figure 46). After performing maintenance, install the
sheet-metal guard and tighten the bolts.
Figure 46
1. Sheet-metal guard
g027946
2. Bolt

Lubrication

Grease more frequently when operating conditions
are extremely dusty or sandy.
Grease Type: No. 2 general-purpose lithium-based
or molybdenum-based grease
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
Note:
Make sure that you scrape any paint off
the front of the fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
Adding Light Oil or Spray
Lubrication
Service Interval: Every 100 hours
Lubricate the deck-lift pivots.
39
EUTRAL
Figure 47
-
LOCK
g017028