Controls System Maintenance; Adjusting The Control-Handle Position; Adjusting The Motion-Control Linkage - Toro Z Master 6000 Professional Series Operator's Manual

Controls System
Maintenance
Adjusting the
Control-Handle Position
There are 2 height positions for the control
levers—high and low. Remove the bolts to adjust the
height for the operator.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the bolts and flange nuts installed in the
levers (Figure 87).
4. Align the levers in the front-to-rear position by
bringing the levers together to the N
position, and slide them until they are aligned,
then tighten the bolts
Figure 87
1. Bolt
2. Handle
-
EUTRAL LOCK
EUTRAL
(Figure 88).
3. Control lever
4. Nut
5. If the ends of the levers hit against each other,
refer to

Adjusting the Control-Handle Position

(page 60).
6. Repeat to adjust the control levers.
Adjusting the
Motion-Control Linkage
Located on either side of the fuel tank, below the seat
are the pump-control linkages. Rotating the pump
linkage with a wrench (1/2 inch) allows fine tuning
adjustments so that the machine does not move in
neutral. Any adjustments should be made for neutral
positioning only.
WARNING
g009040
Engine must be running and drive wheels
must be turning so motion control adjustment
can be performed. Contact with moving parts
or hot surfaces may cause personal injury.
Keep fingers, hands, and clothing clear of
rotating components and hot surfaces.
1. Prior to starting the engine, push the deck-lift
pedal, and remove the height-of-cut pin.
2. Lower deck to the ground.
3. Raise the rear of machine up and support it with
jack stands (or equivalent support).
Note:
Raise the machine just high enough to
allow the drive wheels to turn freely.
60
Figure 88
g009195