Greasing The Mower - Toro Z Master 6000 Professional Series Operator's Manual

Greasing the Mower

Service Interval: Yearly—Grease the pump-belt idler
arm.
Yearly—Grease the front caster pivots (more
often in dirty or dusty conditions).
Yearly—Repack the front caster-wheel bearings
(more often in dirty or dusty conditions).
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the bottom bolt holding the mower-deck
curtain to the mower deck. Refer to
the Mower-Deck Curtain (page
4. Remove the sheet-metal guard. Refer to
Removing the Sheet-Metal Guard (page
5. Grease the mower deck idler-pulley pivot until
grease comes out the bottom
Figure 48
-
EUTRAL LOCK
Releasing
38).
39).
(Figure 48).
10.
11.
12.
g185957
13.
14.
15.
40
6. Grease the drive-belt idler arm
Figure 49
7. Remove the dust cap and adjust the caster
pivots.
Note:
Keep the dust cap off until greasing is
done.
8. Remove the hex plug.
9. Thread a grease fitting into the hole.
Pump grease into the fitting until it oozes out
around the top bearing.
Remove the grease fitting in the hole.
Install the hex plug and dust cap
Figure 50
Grease the caster-wheel bearings
Install the sheet-metal guard. Refer to
the Sheet-Metal Guard (page
Tighten the bolt for the mower-deck curtain.
Refer to Releasing the Mower-Deck Curtain
(page 38).
(Figure 48).
g009030
(Figure 50).
g027339
(Figure 50).
Removing
39).