Toro Z Master 6000 Professional Series Operator's Manual page 64

Figure 93
1. Jack stands
4. Remove both the mower belt and the pump-drive
belt; refer to Replacing the Mower Belt (page
58) and Replacing the Hydraulic Pump-Drive
Belt (page 59).
Note:
This prevents oil from getting on the
belts.
5. Place a drain pan under the filter, remove the
old filter, and wipe the surface clean
Figure 94
Bottom view of the machine
1. Filter locations
6. Apply a thin coat of hydraulic fluid to the rubber
gasket on the replacement filter
g008970
(Figure 94).
g008968
2. Hydraulic filter
(Figure 94).
7. Install the replacement hydraulic filter.
8. Install the pump-drive belt and the mower belt.
9. Remove the jack stands and lower the machine
(Figure 93).
10. Add oil to the hydraulic reservoir and check for
any leaks.
11. Clean up any spilled oil.
12. Start the engine and let it run for about 2 minutes
to purge air from the system.
13. Shut off the engine and check for leaks.
14. Check the oil level while the oil is cold.
15. If required, add oil to the hydraulic reservoir.
Note:
Do not overfill.
64