Subscribe to Our Youtube Channel
Related Manuals for Meinberg IMS-LNE-GBE
Summary of Contents for Meinberg IMS-LNE-GBE
- Page 1 MANUAL IMS-LNE-GBE Setup Guide Hot-Plug Module 26th February 2020 Meinberg Funkuhren GmbH & Co. KG...
-
Page 3: Table Of Contents
......Adding / Removing an LANTIME Network Extension LNE ..... . Date: 26th February 2020 IMS-LNE-GBE Setup Guide... - Page 4 1 Imprint 1 Imprint Meinberg Funkuhren GmbH & Co. KG Lange Wand 9, 31812 Bad Pyrmont / Germany Phone: + 49 (0) 52 81 / 93 09 - 0 Fax: + 49 (0) 52 81 / 93 09 - 230 Internet: https://www.meinbergglobal.com...
-
Page 5: Safety Instructions For Hot Pluggable Modules
• Place the module out of the box or after removal from the system with the component side to the top on a grounded and static-free surface. • Storage of an IMS module must be done in a dry place. • Installation or removal from hot-swap components only by authorized personnel! Date: 26th February 2020 IMS-LNE-GBE Setup Guide... -
Page 6: Additional Safety Hints
To ensure safe operation supply mains connected to this decice must be equipped with a fuse and a fault- current circuit breaker according to the applicable national standards for safe operation. The device must be connected to a protective earth with low grounding resistance according to the applicable national rules. IMS-LNE-GBE Setup Guide Date: 26th February 2020... -
Page 7: Cabling
Wiring or any other work done the connectors particularly when connectors are opened may never be carried out when the installation is energized. All connectors must be covered to prevent from accidental contact to life parts. ALWAYS ENSURE A PROPER INSTALLATION! Date: 26th February 2020 IMS-LNE-GBE Setup Guide... -
Page 8: Replacement Or Installation Of A Hot-Pluggable Ims Module
Make sure that the module is securely locked into the connector block before you fasten the two screws. Now you can put the installed module into operation. Attachment points of an 1U IMS system IMS-LNE-GBE Setup Guide Date: 26th February 2020... -
Page 9: Important Hints For Hot-Pluggable Ims Modules
"System". not "hot swappable" The central management unit must be disconnected from mains before replacement. RSC/SPT not "hot swappable" The RSC switching card must be disconnected from the mains before the replacement. Date: 26th February 2020 IMS-LNE-GBE Setup Guide... -
Page 10: Lne-Gbe: Network Expansion With Gigabit Support And Sfp Option
LNE-GbE and LNE-GbE with SFP Option Option: LNE-SFP Interface: 1000BASE-T SFP Cable: Multimode Fiber GI 50/125 m or GI 62,5/125 m gradient fiber Singlemode Fiber E9/125 m monomode fiber Link Speed Electrical: 1000 Base-T Fiber optical: 1000-FX IMS-LNE-GBE Setup Guide Date: 26th February 2020... - Page 11 In a factory assembling, LNE modules are sorted in an ascending order starting from left to right (see the corresponding figure above). LAN 0 is therefore always the first network interface of the LAN-CPU. Date: 26th February 2020 IMS-LNE-GBE Setup Guide...
-
Page 12: Lne-Gbe Configuration Via The Web Interface
IPv6 Mode: This mode must be activated here. MAC-Address: Displays the unique MAC address of the physical interface. Assigned Virtual Interfaces: In the Ethernet Interfaces menu (see below) virtual network interfaces can be added. IMS-LNE-GBE Setup Guide Date: 26th February 2020... - Page 13 With VLAN, this function can be enabled and configured. Cluster: The cluster function can be activated with this submenu and additional Parameters such as multicast or unicast mode, TCP / IP address and subnet mask can be set up here. Date: 26th February 2020 IMS-LNE-GBE Setup Guide...
-
Page 14: Adding / Removing An Lantime Network Extension Lne
LNE interfaces are still listed in the network configuration. The "NIC Manager" can be used to update the network configuration in this case as well. After successfully running the "NIC Manager", only the actually existing interfaces are displayed in the web interface. A system restart is not necessary. IMS-LNE-GBE Setup Guide Date: 26th February 2020...
Need help?
Do you have a question about the IMS-LNE-GBE and is the answer not in the manual?
Questions and answers