12.12
Adjusting the steering head bearing play
12.13
Lubricating the steering head bearing
–
Check the steering head bearing and replace if neces-
sary.
–
Check the steering stop bolts for correct adjustment and lock-
ing.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
K01336-10
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screw
Guideline
Screw, top steering
stem
Finishing work
–
Check the steering head bearing for play. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated in
the course of removal and installation of the lower triple
clamp.
H02387-01
SERVICE WORK ON THE CHASSIS 12
1
2
and
.
3
.
M20x1.5
12 Nm (8.9 lbf ft)
1
.
M8
20 Nm (14.8 lbf ft)
2
.
M8
20 Nm (14.8 lbf ft)
(
p. 63)
(
p. 64)
p. 60)
p. 60)
p. 66)
p. 60)
67