18 SERVICE WORK ON THE ENGINE
130
–
Pull oil filter
Lock ring plier (51012011000)
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surface.
K00572-10
–
Lay the motorcycle on its right side and fill the oil filter hous-
ing approx. ⅓ full with engine oil.
–
Place the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
K00573-10
–
Stand the motorcycle upright.
–
Remove filler plug
O-ring, and fill up with engine oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
401955-12
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check for leaks.
Finishing work
–
Check the engine oil level. (
6
out of the oil filter housing.
7
.
M6
8
from the clutch cover together with the
1.0 l (1.1 qt.)
p. 128)
10 Nm (7.4 lbf ft)
Engine oil
(SAE 10W/50)
(
p. 147)