Vermont Castings Stardance SDDVT Series Installation & Operating Manual page 22

Figure 3.21
4" Flex Pipe
(Included in Link-Stove Kit)
Figure 3.22
5. Pull the flex pipe down through the ceiling support box,
until it protrudes approximately 3 in. (76mm). Connect
the flex pipe to the retro connector, and attach with sheet
metal screws.
6. Push the flex pipe back up into the ceiling support box,
center the retro connector, and attach it to the support
box with sheet metal screws.
7. The connection between the appliance and the retro
connector may be completed with sections of direct vent
pipe.
2222
Top Adapter
(Included in Link-Stove Kit)
Sheet Metal Screws
Vermont Castings • Stardance SDDVT Installation Manual_R23 • 11/21
Existing Masonry Chimney
Prior to installing the gas stove, ensure that the existing
chimney is functionally sound and clean.
• Have the chimney and adjacent structure inspected and
cleaned by qualified professionals. Hearth & Home
Technologies recommends that NFI or CSIA certified
professionals, or technicians under the direction of
certified professionals, conduct a minimum of a NFPA
211 Level 2 inspection of the chimney.
• Replace component parts of the chimney and fireplaceas
specified by the professionals.
Up & Out Installation
Top Adaptor
(Included in Masonry Chimney
Conversion Kit & LINK-STOVE Kit)
Retro Connector
(Included in Masonry Chimney
Conversion Kit & LINK-STOVE Kit)
90° Elbow
Direct Vent Pipe
(Length as required)
Figure 3.23
Termination Cap
(Included in LINK-STOVE Kit)
Flashing
(Included in Masonry
Chimney Conversion Kit &
LINK-STOVE Kit)
4 in. (102mm) Flex Liner
(Included in LINK-STOVE Kit)
3-90-30007467