Advertisement
ASSEMBLY
13.
Using a soft mallet push the female shock
mounting hardware through the frame and shock
on the Fox Guide Pins.
15.
Time to get the torque wrench out. Using a 5mm
allen on one side and your properly calibrated
torque wrench on the other torque the shock
mounting hardware on both ends of the shock.
Torque to 7 Nm
24.
14.
Prep and install the male shock mounting
hardware on both ends of the shock. Apply Blue
Loctite (248) to the threads and install the washer.
Thread the bolt in snug, but do not torque.
16.
Using a 10mm allen wrench finish tightening the
main pivot axle and the upper link axle. Torque
the pivot axles using a properly calibrated torque
wrench.
Torque to 3.5 Nm
17.
Prepare both your collet bolts with grease. You
want to have grease on the threads and on the
collet wedge.
FRAME ASSEMBLY IS COMPLETE. NOW
GET YOUR PARTS ON THERE AND GO FOR
A RIDE!
ASSEMBLY
18.
Using a 5mm allen wrench, thread both collet
bolts into the pivot axles. Finish tightening using
a properly calibrated torque wrench.
Torque to 8 Nm
25.
Advertisement
