Power Requirements - Thermo Scientific TSQ 8000 Evo Preinstallation Manual

Power Requirements

Table 3. System Power Requirements (Sheet 1 of 2)
Equipment
1
TSQ 8000 Evo MS
2
Foreline pump
2,3
Optional mech pump
TRACE 1300 and TRACE 1310
4
Computer
4
Monitor
AI/AS 1310 Sampling systems
5
TriPlus RSH Sampling system
TriPlus 100 Liquid Sampler
Thermo Scientific
2. You may need a small, high-intensity lamp when you clean the TSQ 8000 Evo or work
inside the GC column oven.
Use the following guidelines to ensure your site is equipped with enough power to support the
system. All circuits should be 50/60 Hz ± 2 Hz, single-phase with < 6% total harmonic
distortion.
• Circuit 1: TSQ 8000 Evo MS plus the foreline pump and optional mech pump.
100-240 Vac, 15 A
voltage used at your location.
• Circuit 2: GC. 120 Vac +6/-10%, 16 A
your customer sales order to determine if the GC is 120 Vac or 230 Vac. The GC
cannot be reconfigured in the field.
• Additional Circuits: Additional circuits are needed for the computer or other
equipment. 120 Vac +6/-10% or 230 Vac ±10%.
Note Due to the power draw of the TSQ 8000 Evo MS and GC, each instrument must
be on its own dedicated circuit. These two circuits must be separate from the circuits used
for the computer and other equipment such as the autosampler.
Circuits
1
N/A
N/A
1
2
Additional
(as needed)
Additional
(as needed)
Additional
(as needed)
Additional
(as needed)
Additional
(as needed)
. The foreline pump and mech pump must be set to the line
MAX
MAX
Max Current Max Current
(A) at 120 Vac (A) at 230 Vac
(+ 6/- 10%) (± 10%)
5.9 3.1
4.6 2.7
4.6 2.7
16 10
5 2.6
2 1
0.8 0.4
3.2 1.7
– –
TSQ 8000 Evo Preinstallation Requirements Guide
1
Power Requirements
or 230 Vac ±10%, 10 A
MAX
Maximum Power (W)
710
550
550
2000
600
240
95
200 with one power module
400 with two power modules
200 with one power module
400 with two power modules
Site Preparation
. Refer to
7