Table of Contents
Advertisement
Indicates charging when in charger cradle.
nd
rd
d. The 2
and 3
lines of the LCD, maximum 14 characters each, display
status, message, menu selections, or user-editable alphanumerical
characters.
e
The last line displays the left and right soft keys.
2. Ringer
a. Rings to an incoming call.
b. Distinctive alert sounds indicating various events:
(1) Single Beep: successful key entry
(2) Double beep: failed operation or invalid key entry, also indicates
power on/off
(3) Periodic 1-Long-2-Short Beep (every 1 minute): low battery warning
(4) Periodic Long Series of Beeps (repeat every 30 seconds): indicates a
call is on-hold
3. TALK/FLASH (
)
a. Places or answers a telephone or intercom call
b. Sends a Flash signal to phone line to retrieve a dial tone after the call ends,
or to perform the call waiting feature provided by local phone companies
during a call.
c.
Press and hold the key for one second to enable/disable speakerphone.
4. SPEAKERPHONE (
)
a
Press the key to enable/disable the speakerphone during incoming,
outgoing or intercom call.
b. During IDLE mode, press and hold the key to activate/deactivate
Monitoring
5. 2-WAY INTERCOM (
)
a. Places an intercom call to another handset ID or a group ID (group paging).
b. Intercom calls are digital, full duplex, and are conducted without the
assistance from the base.
6. PTT
a. Activate the half duplex broadcasting via UHF band or 900MHz band
b. Press the Mode key repeatedly to set the desired channel (1~5) in advance.
Re. PTT operation should be limited to 50% duty cycle.
7. Left/Right Soft Keys(
/
Make menu selection.
)
~15~
8. Up(
) /Down(
) Scrolling Keys
a. Scroll through records and menu selections.
b. Adjust receiver voice volume when in Talk mode.
9.
END Key (
)
a. Ends a call.
b. Leaves current menu operation, up one level.
10.
MODE Key (
)
a. Select channel of UHF 2-way radio
b. Setting channel/Frequency/ Code/Microphone gain/VOX in programming
mode
c.
During IDLE mode, press and hold the key to activate/deactivate scanning.
.
Note, to access programming mode for 2-way radio, press and hold this MODE
button while turning the radio on
11. Walkie LED
a. The Walkie LED on the front of handset is red light when transmitting.
b. Static green is to indicate receiving UHF signal
c.
Standby LED blinks in green
Additional Handset Features
2. Multiple handsets registration (Register to PRO base)
a.
Up to 90 handsets.
b.
ID 10 and 11 are the first two ID's assigned by the base and are designated
"administrators" who can change base settings such as greeting message
and other base administrative functions.
Note: Unless necessary, it is better not to assign ID 10 and 11 to
DuraWalkie handsets.
c.
ID 01-07: Group IDs. Handsets can "subscribe" from the handset menu to
group(s) and be paged when a landline caller or an intercom caller enters
a Group ID.
3.
Ringer / Vibrator
a.
Six-level ringer volume selections (high/ medium/low/ vibrate/ vibrate-
then-ring/ off)
b. Four ringer type selections
~16~
Advertisement
Table of Contents
