Table of Contents
Advertisement
( "01" ~ "07" for Group ID: "10" ~ "99" for Handset ID: "00" for
all).
a.
The greeting message : "Please enter the extension number"
b.
If there is no entry after 5 seconds, the broadcast will be
enabled to all handsets.
Note：
1. Line 3 and or 4 can be reserved for broadcast function.
2. For a single broadcast port; reserve Line 3 for broadcast and line
dedicate (see pg. 46) Line 4 to a non-existent handset (ie: 99).
3. A base unit configured with a single broadcast port Lines 1 and 2
may be used as standard telephone ports or lines.
4. For dual broadcast ports; reserve Line 3 and 4 for broadcast and line
dedicate Lines 1 and 2 to a non-existent handset (ie: 99)
5. Broadcast is limited to 30 seconds.
Repeater Operation
1.
Due to the range performance of handset to handset calls
(intercom or broadcast) isn't as good as line calls, in order to get
better range performance for handset to handset calls, install a
repeater and make the calls via repeater is the solution.
2.
The procedure of repeater's registration is same as the multi-base
which can be performed by administrator handset (Handset 10
and 11).
3.
From an administrator handset (Handset 10 or 11), press
7
to enter the "BC/INT Type" menu setting.
4.
Press
or
key to select "Repeater Mode", then press
SAVE
(Left softkey)to confirm the selection.
Re : When setting to "Repeater" mode, the handset to handset
calls will always via repeater.
5.
Enter the base number (00~07) which assigned the base to be a
repeater.
6.
The default of "BC/INT Type" is "P2P Mode".
MENU
–
~53~
Notes:
a. The repeater must work with PRO system.
b. A repeater can only support 2 simultaneous intercom calls (2 pairs handsets).
Or can only support 1 broadcast call.
c . In order to operate with a PRO system, the repeater must be assigned a base
ID from the PRO system, please refer to the multi-base setup to add the
repeater as a multi-base.
d. The handsets which intend to work with the repeater require enabling a
"Repeater Mode".
e. When enabling the "Repeater Mode", both intercom and broadcast calls will go
via the repeater, instead of the original direct handset to handset (P2P mode).
f. A repeater will no linger to support any PSTN call.
g. No support put the repeaters in cascade.
~54~
Advertisement
Table of Contents
