Table of Contents
Advertisement
Charger Features
1.
DC In
Connects to Charger AC Adaptor.
2.
Handset Charging Slot
a.
Charge handset battery when handset is placed in cradle.
b. Refer to the handset LCD for charging status
(1) Charging: battery status bar is running and the LCD screen showed:
Charging
(2) Fully Charged: battery status bar stands still and the LCD screen would
display "Fully Charged"
(3) Charge Fail: Should there be any error occurred during charging mode,
the LCD screen would display "Charge Fail"
3.
Spare Battery Charging Slot
a
Charge spare battery when battery is placed in slot.
b. LED as the spare battery charging indicator
(1) Charging: LED is green light
(2) Full charged or slot is empty: LED is off
4.
It is impossible to overcharge the battery using this charger.
Notes:
1. Fully charge battery packs before first use.
2. Both handset and spare batteries can be charged at the same time.
~21~
Getting Started
Handset and Charger Installation
1.
Plug the transformer end of the Charger AC/DC adaptor into a standard AC
electric power outlet, plug the other end into the "DC In" jack on the back of
the Charger.
2.
Install battery pack onto the handset.
3.
Install handset antenna.
4.
Place handset onto the charger front slot.
5.
Fully charge the battery for three hours before use.
6.
The phone system is now ready to perform basic functions such as making and
receiving phone calls and intercom calls. No base station or handset
programming is needed for basic operations.
Note:
1.
Handset(s) packaged along with a Base Station are pre-
registered at the factory. If you have a new handset, you will
need to register the handset with the base station in order to
be recognized as a member handset by the base(s) and by
other handsets. See Handset Registration.
Fully charge battery packs before the first usage.
2.
~22~
Advertisement
Table of Contents
