Table of Contents
Advertisement
Placing a Call On Hold
1.
When a call is in progress, it can be put on hold by
pressing the
HOLD
(Right) soft key.
To return to the conversation, press
2.
Notes:
1. The call being placed on hold can only be "un-hold" by the
handset that puts it on hold.
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.
4. You can power off the handset (e.g., change battery) while call
is on hold. After power on again, you can continue the call by
pressing
UNHOLD
(Left) soft key to terminate the hold state.
Mute
1.
After a link is established, you can press
press "0" to mute the handset microphone.
2.
When mute is active, the other end will not hear your voice, but still can speak
to you.
3.
To leave the mute state, press
UNMUTE
for the current call.
Do Not Disturb (Silent Ring)
1.
Enter the key sequence
MENU
Press
SAVE
to confirm your choice. This will turn off the
ringer until it is turn on again from the menu.
2.
For temporary silencing the ringer when an incoming call
arrives, press
SILENT
(Left) soft key.
10 1
You have a
Call on hold
UNHOLD OPTION
UNHOLD
OPTION
(Left) soft key and
(Left) soft key. Mute is effective only
Sounds:
- 4 - 1, then select "Off".
1. Ring Volume
2. Ring Tone
Ring Volume:
Off
SAVE
~31~
Key Guard
1.
To prevent accidental dialing, you can press
soft key, then press "1" to select KeyGuard option. The
handset keypad is locked. No key entry is accepted except
the power on/off key.
2.
To unlock the keypad, press
within 2 seconds, press the digit "1" to unlock.
3.
Key Guard is in effect until unlocked or powered off.
To View Missed Call(s)
1.
Whenever you have missed incoming call(s), you can
Press
2.
You need to subscribe the caller ID service from local
telecom company to retrieve this data.
To Call back from Call Log
1.
When you review missed incoming call(s), you can directly call back
by pressing
2.
The displayed CID number in most cases will be a 10-digit number
with the 3-digit area code followed by the 7-digit telephone
number. If the area code is unnecessary for calling back, you can
follow below rule to adjust the calling back number:
a. Press
10
b. Press
displayed number.
c. Press
displayed number.
Re:The CID default is 10 digits, when press
10
7-digit –> 11-digit –> 10-digit in circle.
UNLOCK
(Left) soft key, then,
VIEW
soft key to enter the call logs information.
key.
FORMAT
key once, the 3-digit area code will be removed.
FORMAT
key twice, "1" will be added in front of the
FORMAT
key three times, it will loop back original
~32~
11
MENU
(Right)
DuraFon PRO
UNLOCK
10
Press 1 to
confirm
unlock
10
You have 1
missed call
VIEW
MENU
FORMAT
key, it will be
Advertisement
Table of Contents
