Advertisement

Quick Links

EC18000VE/D
EC22000VE/A
GENERATORS
INSTALLATION AND
OPERATORS
MANUAL
WINCO INC. 225 S. CORDOVA AVE. LE CENTER, MN 56057 507-357-6821
SERVICE DEPT. 507-357-6831
www.wincogen.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EC18000VE/D and is the answer not in the manual?

Questions and answers

Summary of Contents for Winco EC18000VE/D

  • Page 1 EC18000VE/D EC22000VE/A GENERATORS INSTALLATION AND OPERATORS MANUAL WINCO INC. 225 S. CORDOVA AVE. LE CENTER, MN 56057 507-357-6821 SERVICE DEPT. 507-357-6831 www.wincogen.com...
  • Page 2: Table Of Contents

    VENTILATION GASOLINE COPY YOUR MODEL AND SERIAL NUMBER HERE FUEL SUPPLY No other WINCO generator has the same serial number as yours. If LUBRICATION you should ever need to contact us concerning this unit, it will help us OIL RECOMMENDATIONS to respond to your needs faster.
  • Page 3: Specifications

    SPECIFICATIONS EC18000VE EC22000VE Starting Watts 18,000 Starting Watts 22,000 22,000 22,000 22,000 Running Watts 15,000 Running Watts 19,000 19,000 19,000 19,000 Volts 120/240 Volts 120/240 120/208 120/240 277/480 Phase 62.5 Phase Single Three Three Three Amps 120/240V 125/62.5 Amps CB Size 60 Amp CB Size 80 Amp...
  • Page 4: Safety

    SAFETY A. Do not refuel when the engine is running or hot. B. Keep fuel containers out of reach of children. IMPORTANT SAFETY INSTRUCTIONS C. Do not smoke or use open flame near the generator set or fuel tank. SAVE THESE INSTRUCTIONS D.
  • Page 5: Introduction

    INTRODUCTION INTENDED USES The EC18000VE engine generator set has been designed primarily for heavy duty commercial use. A 240 volt receptacle is provided in the control panel to plug in your loads. The EC22000VE is hard-wire connectible only. These units are dual wound generators, therefore the 120 volt loads must be equally split with 1/2 of the rated capacity available on each of the two 120 volt circuits.
  • Page 6: Preparing The Unit

    Always ensure that the let WINCO take care of the freight claim. If you sign for the unit, the fuel is clean and free of all impurities.
  • Page 7: Lubrication

    LUBRICATION to prevent severe damage caused by an insufficient amount of oil in the crankcase. However, if the unit is repeatedly allowed to shutdown on low oil pressure, progressive damage will be done to the engine, Before starting the engine, fill the crankcase to the proper level with shortening the engine’s life.
  • Page 8: Initial Start Up

    INITIAL START UP STOPPING AND STORING 1. Move the key to the “OFF” position. 2. Turn off the fuel supply valve. The throttle control on these generators is preset and locked to operate 3. Before extended storage (over 30 days) certain precautions at 3600 RPM (nominal) with no load speed set at 3690 RPM.
  • Page 9: Connecting The Loads

    APPLYING THE LOADS LOAD vs. OUTPUT Generator Speed Frequency Voltage Allow the engine to warm up for two or three minutes before applying Load (RPM) (Hz) any load. This will allow the engine to reach normal operating None 3690 61.5 125V temperature and oil to circulate throughout the engine.
  • Page 10: Engine Care

    ENGINE CARE C. Remove the oil filter and dispose of it properly. D. Before you install the new oil filter, clean the filter mounting base and coat the seal of the new oil filter will clean engine oil. ENGINE CARE e.
  • Page 11: Carbon Canister

    TROUBLESHOOTING CARBON CANISTER Problem Possible Causes Designed to collect, store, and dispose of fuel vapors created in the Won’t start Low oil level fuel tank/fuel system. The canister should last the life of the unit as long Fouled spark plug as it stays dry.
  • Page 12: Outline Drawings

    60706-231 OPERATOR MANUAL 4/27/2012 THIS DRAWING CONTAINS TITLE: +/- 0.0625 DECIMAL PROPRIETARY 526-000 5/16 FLAT WASHER TOLERANCE: +/- 1 DEG ANGULAR EC22000VE INFORMATION BELONGING TO WINCO, EC22000VE/A UNAUTHORIZED USE IS MODEL: PROHIBITED 467-000 HHCS 5/16-18X.75 19022-000 PART: ALL DIMESNIONS INCH...
  • Page 13: Distribution Wiring Schematics

    DISTRIBUTION WIRING SCHEMATICS EC18000VE EC22000VE 120/240 SINGLE PHASE 120/208 & 120/240 THREE PHASE 277/480 THREE PHASE 60706-231 REV D...
  • Page 14: Ec22000Ve Ac Wiring

    THREE PHASE AC WIRING EC22000VE AC WIRING HIGH AND LOW WYE 3-PHASE THREE PHASE-HIGH WYE THREE PHASE-LO 277/430 HIGH WYE 277/480 VOLTS 120/208 VOLTS EE PHASE AC WIRING H AND LOW WYE E-HIGH WYE THREE PHASE-LOW WYE 3-PHASE 120/208 VOLTS 120/208 LOW WYE REV D 60706-231...
  • Page 15 THREE PHASE AC WIRING - D SINGLE PHASE AC WIRING 1-PHASE SINGLE PHASE THREE PHASE -D 120/240 VOLTS 120/240 VOLTS 120/240 E PHASE AC WIRING - DELTA E PHASE AC WIRING 3-PHASE GLE PHASE THREE PHASE -DELTA 120/240 DELTA 240 VOLTS 120/240 VOLTS 60706-231 REV D...
  • Page 16: 24 Month Limited Warranty

    WINCO written instructions. WINCO’s sole liability, and Purchaser’s sole remedy for a failure under this warranty, shall be limited to the repair of the product. At WINCO’s option, material found to be defective in material or workmanship under normal use and service will be repaired or replaced.

This manual is also suitable for:

Ec22000ve/a

Table of Contents