Specifications; Generator; Engine - Generac Power Systems 9 kW Owner's Manual

Specifications

Generator

Model
Rated Voltage
Rated Maximum Load
Current (Amps) at Rated
Voltage with LP*
Main Line Circuit Breaker
(Generator Disconnect)
Phase
Rated AC Frequency
Battery Requirement
(Field supplied)
Enclosure
Weight (lbs/kilos)
(without battery)
Normal Operating Range
These generators are rated in accordance with UL 2200, Safety Standard for Stationary Engine Generator Assemblies, and CSA-C22.2 No. 100-04
Standard for Motors and Generators.
* Natural Gas ratings will depend on specific fuel joules/BTU content. Typical derates are between 10-20% off the LP gas rating.

Engine

Model
Type of Engine
Number of Cylinders
Displacement
Cylinder Block
Recommended Spark Plug
Spark Plug Gap
Valve Clearance
Starter
Oil Capacity Including Filter
Recommended Oil Filter
Recommended Air Filter
Engine power is subject to and limited by such factors as fuel BTU/joules, ambient temperature and altitude. Engine power decreases about 3.5% for
each 1000 ft (304.8 m) above sea level, and also will decrease about 1% for each 10 °F (6 °C) above 60 °F (15 °C) ambient temperature.
The specification sheet for your generator was included in the documentation provided with the unit at the time of
purchase. For additional copies, consult your local Independent Authorized Service Dealer (IASD) for your specific
generator model.
Owner's Manual for 60 Hz Air-Cooled Generators
9 kW 11 kW
37.5 45.8
40 Amp 50 Amp
12 volts, Group 26R-540CCA Minimum or Group 35AGM-650CCA Minimum
340/154 348/158
This unit is tested in accordance to UL 2200 standards with an operating temperature of -20 °F (-29 °C) to 122 °F
(50 °C). For areas where temperatures fall below 32 °F (0 °C) a cold weather kit is recommended. When operated
above 77 °F (25 °C) there may be a decrease in engine power. See
9 kW
GH-426
1
426 cc
0.020 in (0.508 mm)
0.002–0.004 in
(0.05–0.1 mm)
Approx. 1.1 qt (1.03 L)
16 kW
240
66.6
70 Amp
1
60 Hz
Replacement Parts
(see
Aluminum
409/186
Engine
11 kW
GTH-530
2
530 cc
Aluminum w/ cast iron sleeve
Replacement Parts
See
0.030 in (0.76 mm)
0.002–0.004 in
(0.05–0.1 mm)
12 VDC
Approx. 1.7 qt (1.6 L)
Replacement Parts
See
Replacement Parts
See
General Information
20 kW 22 kW
83.3 91.7
100 Amp 100 Amp
)
448/203 466/211
.
16/20/22 kW
GT-999
2
999 cc
0.040 in (1.02 mm)
0.002–0.004 in
(0.05–0.1 mm)
Approx. 1.9 qt (1.8 L)
7