Service Schedule; Maintenance Log - Generac Power Systems 9 kW Owner's Manual

Maintenance

Service Schedule

Service
Check enclosure louvers for dirt and debris *
Check lines and connections for fuel or oil leaks
Check engine oil level
Check for water intrusion **
Check battery condition, electrolyte level, and state
of charge
Replace engine oil and oil filter †
Replace engine air filter
Clean; Check gap; Replace spark plugs
Inspect/adjust valve clearance ‡
Inspect/clean sediment trap
Contact the nearest IASD for assistance if necessary.
* Remove any shrubs or tall grasses which have grown within 3 ft (0.91 m) of the intake and discharge louvers on the sides of the enclosure. Clean any debris (dirt,
grass clippings, etc.) which have accumulated inside the enclosure.
** Verify that all sources of potential water intrusion such as water sprinklers, roof run-off, rain gutter down spouts, and sump pump discharges are directed away
from the generator enclosure.
† Change engine oil and filter after the first 25 hours of operation. In cold weather conditions (ambient below 40 °F / 4.4 °C), or if unit is operated continuously in hot
weather conditions (ambient above 85 °F / 29.4 °C), change engine oil and filter every year or 100 hours of operation.
‡ Check/adjust valve clearance after the first 25 hours of operation.
NOTE: Contact an IASD or visit

Maintenance Log

Battery inspection and charge check
Dates Performed:
Oil, oil filter, air filter, and spark plug replacement
Dates Performed:
Valve Adjustment
Dates Performed:
24
Daily If Running Continuously
or Before Each Use
●
●
●
www.generac.com for additional information on replacement parts.
Schedule A
Every
Every Two Years
Year
or 200 Hours
●
● ●
●
Consult local codes and guidelines.
Owner's Manual for 60 Hz Air-Cooled Generators
Schedule B
Every Four Years
or 400 Hours
●
●
●
●
●