Table of Contents
Advertisement
6.4 Example 4: Capturing Single-shot Signal
You may refer to the following example to easily capture some aperiodic signals like pulses and
glitches.
To set for a single-shot acquisition, follow the steps below.
1.
First, set up the oscilloscope probe and the attenuation factor of CH1.
2.
Turn the vertical VOLTS/DIV and horizontal SEC/DIV knobs to a proper position for a better
examination of the signal.
3.
Press the ACQUIRE button to see the Acquire menu.
4.
Push the Peak Detect option button.
5.
Push the TRIG MENU button and select Rising for the Slope option. Then adjust the trigger
level properly.
6.
Push the SINGLE SEQ button to start the acquisition.
Using this feature can help you to capture occasional events more easily. This is an advantage of
the digital storage oscilloscope.
6.5 Example 5: Using X-Y Mode
Viewing Phase Differences between Two Channel Signals
For example, you need to measure the change in a phase across a circuit network.
Connect the oscilloscope with circuitry and view the input and output of the circuit in XY mode.
Follow the steps below.
DSO5000 Series Digital Storage Oscilloscope User Manual
Application Examples
57
Advertisement
Table of Contents
