Table of Contents
Advertisement
SINGLE SEQ: Acquire a single waveform and then stop the acquisition.
RUN/STOP: Continuously acquire waveforms or stop the acquisition.
HELP: Display the Help menu.
DEFAULT SETUP: Recall the factory setup. Refer to the following table for relative content.
Save to USB Disk: Save all displays on the screen to a USB device, just like the screen
capturing function of a computer.
5.6.1AUTOSET
Autoset is one of the advantages digital oscilloscopes have. When you push the AUTOSET
button, the oscilloscope will identify the type of waveform (sine or square wave) and adjust
controls according to input signals so that it can accurately display the waveform of the input
signal.
Functions
Acquire Mode
Cursor
Display Format
Display Type
Horizontal Position
SEC/DIV
Trigger Coupling
Trigger Holdoff
Trigger Level
Trigger Mode
Trigger Source
Trigger Slope
Trigger Type
Trigger Video Sync
Trigger Video Standard
Vertical Bandwidth
Vertical Coupling
VOLTS/DIV
The Autoset function examines all channels for signals and displays corresponding waveforms.
Autoset determines the trigger source according to the following conditions.
If multiply channels get signals, the oscilloscope will use the channel with the lowest
frequency signal as the trigger source.
If no signals are found, the oscilloscope will use the lowest-numbered channel displayed
in Autoset as the trigger source.
DSO5000 Series Digital Storage Oscilloscope User Manual
Adjusted to Normal or Peak Detect
Off
Set to YT
Set to Vectors for an FFT spectrum; otherwise, unchanged
Adjusted
Adjusted
Adjusted to DC, Noise Reject or HF Reject
Minimum
Set to 50%
Auto
Adjusted; Autoset can not be used for the EXT TRIG signal
Adjusted
Edge
Adjusted
Adjusted
Full
DC (if GND was chosen before); AC for the video signal; otherwise,
unchanged
Adjusted
Settings
44
Basic Operation
Advertisement
Table of Contents
