Table of Contents
Advertisement
3. The pins must be open to keep the UPS running. If the UPS shuts down
4. To avoid accidental load loss, always test the remote emergency power-off
To connect a remote emergency power-off switch, complete the following steps:
1. Turn off the UPS, disconnect all external cables, and make sure that the UPS is
2. Remove the remote emergency power-off connector from the accessory kit.
12
6000 VA UPS and 6000 VA EBM: Installation and Maintenance Guide
because the remote emergency power-off connector pins are shorted, restart
the UPS by reopening the remote emergency power-off connector pins and
turning on the UPS manually. Maximum resistance in the shorted loop is 10
ohm.
function before you apply your critical load.
disconnected from utility power.
Note: Make sure that no jumper is installed in the remote emergency power-off
connector. If a jumper is installed, remove it before you connect to the remote
emergency power-off connector.
Advertisement
Table of Contents
