Slow Start Pattern - Brother BAS H Series Instruction Manual

1-2-2. Slow start pattern

Set memory switch No. 100 to ON and then touch the Slow Start key (5) in the sewing operation screen to display
the slow start setting screen.
This is used to stop the thread from pulling out at the sewing start, and at times when skipped stitches might easily
occur.
* When memory switch no. 400 is set to ON, slow start patterns can be recorded separately for each program
number.
(3)
Slow Start (1)
OK key (2)
Cancel key (3)
Reset key (4)
Table Setting values and starting-up speeds
Sewing speed for 1st stitch
Sewing speed for 2nd stitch
Sewing speed for 3rd stitch
Sewing speed for 4th stitch
*1 Sewing will be carried out at the sewing speed which is set by the "Sewing speed" parameter.
Touch the △ or ▽ key to adjust the starting-up speed at the sewing
start.
* The smaller the number, the slower the start.
* Refer to the following table for the speed setting values.
Touch to confirm the setting value and return to the sewing operation
screen.
Touch to return to the sewing operation screen without changing the
setting value.
Touch to return the value to the value which was first displayed when
you switched to the setting screen.
Lo 1 2 3
200 200 300
200 300 400
300 400 500
500 600 700
BAS H series
1. USING THE LCD PANEL (BASIC OPERATIONS)
(1)
(4)
4 5 6
400 400 400
400 500 600
600 800 1000 1200
900 1200 1400
(2)
7 8 9
400 600 800
800 1000 1200
1600 *1
*1 *1 *1
7