golmar SV-372S Color Instruction Manual page 10

MONITOR DESCRIPTION
F
unction push buttons.
Push button to stablish / finish communication or intercom function (only available on systems
with 2 or more monitors in the same apartment, for description and connection see page
52, 55 & 57).
In configuration menu mode: To scroll up through the menu or to increase the value of the
selected option, (see page 53).
Push button for a
door paneI during 90 seconds (if exists more than one door panel, pushing each time, the
picture and audio will switch from a door panel to the other one), to establish audio and
video communication with the door panel
last for 90 seconds or until press
In configuration menu mode: To scroll down through the menu or to decrease the value of the
selected option, (see page 53).
Push button to activate the lock release. During call reception, communication and
autoswitch-on processes, it allows lock release activation. During activation, the picture
will disappear from the monitor screen.
In configuration menu mode: Select / deselect the desired option, (see page 53).
Push button to activate the auxiliary device. D
autoswitch-on processes
Push button to enter / exit the configuration menu mode (see page 53).
S
witch 'end of line resistor'.
The switch 'end of line resistor' is located
monitor . Place
for intermediate monitors
*Factory default
utoswitch-on. It allows to visualize the picture and to listen the audio with the
, activate the auxiliary device (see page 59).
to ON the monitor where bus wires terminate, set to OFF only
.
press push button. The communication will
push button monitor again.
uring call reception, communication and
at the left side of the back of the
49