Numatic TTB 4055/100 Owner's Instructions Manual page 10

Do not use on surfaces have a gradient exceeding that marked on the machine.
2QO\ XVH EUXVKHV SURYLGHG ZLWK WKH DSSOLDQFH RU WKRVH VSHFL¿HG LQ WKH LQVWUXFWLRQ PDQXDO
The use of other brushes may impair safety.
WARNING
A full range of brushes and accessories are available for this product.
2QO\ XVH EUXVKHV RU SDGV ZKLFK DUH VXLWDEOH IRU WKH FRUUHFW RSHUDWLRQ RI WKH PDFKLQH IRU WKH VSHFL¿F WDVN EHLQJ
performed.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations.
When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the
operator and any other persons who may be affected.
Wear non-slip footwear when scrubbing. Use a respiratory mask in dusty environments.
The machine, while charging, must be positioned so that the mains plug is easily accessible.
When cleaning, servicing or maintaining the machine, replacing parts or converting to another function the power
source shall be switched off.
Mains operated machines shall be disconnected by removing the power plug, and battery operated machines shall be
disconnected by switching off the isolating key.
Machines left unattended shall be secured against unintentional movement.
Operators shall be adequately instructed as to the correct use of the machine.
1. Always wear protective clothing e.g. Face visor, gloves and overalls when working with batteries
2. Whenever possible always use a properly designated and well-ventilated area for charging. Do not smoke or bring
QDNHG ÀDPHV LQWR WKH FKDUJLQJ DUHD
3. Remove any metallic items from hands, wrists and neck i.e. Rings, chains etc. before working on a battery.
4. Never rest tools or metallic objects on top of the battery.
5. When charging is complete disconnect from the mains supply.
6. The batteries must be removed from the machine before it is scrapped.
7. The machine must be disconnected from the supply when removing the battery.
8. The batteries are to be disposed of safely and in accordance with the battery directive.
9. Only use genuine NUMATIC replacement batteries.
10. Do not allow the batteries to become fully discharged; it may not be possible to recharge them. Batteries should
QRW EH GLVFKDUJHG EHORZ  YROWV ZLWK  DPSV ÀRZLQJ
11. Do not allow one battery to be discharged separately to the other.
12.Do not mix batteries from different machines.
 7KH EDWWHULHV ¿WWHG WR WKLV SURGXFW DUH 9DOYH 5HJXODWHG /HDG $FLG 95/$ JHO HOHFWURO\WH W\SH 7KH ¿WWLQJ RI DQ\
other type of battery may cause a safety hazard.
1. Always recharge the batteries after use. This can be done at any time its not necessary to wait until they are fully
discharged; they do not develop a "memory".
2. Leaving the charger to operate for a minimum of 4 hours after the green light has come on, at least weekly, will
prolong battery life.
3. Do not store the machine with the batteries discharged.
Daily
Keep the machine clean
(QVXUH EUXVKHV SDGV VTXHHJHH ¿OWHUV DUH LQ JRRG FRQGLWLRQ
Check for any worn or damaged parts and replace immediately
Drain and rinse dirty water tank after every use
Store machine with brush deck secured in tilted position
Weekly – as daily and –
Check brush or pad and skirt and rinse
&KHFN ÀRRU WRRO EODGHV IRU ZHDU DQG ZLSH FOHDQ
&OHDQ VHSDUDWRU DVVHPEO\ LQFOXGLQJ ¿OWHU DQG FKHFN FRQGLWLRQ RI VHDO
)OXVK RXW V\VWHP ZLWK FOHDQ ZDWHU DQG FOHDQ ¿OWHUV
Do not steam clean or pressure wash
Batteries
Always recharge the batteries after use
Charge for a minimum of 4 hours after the green light has come on as this will prolong battery life
PRECAUTIONS WHEN WORKING WITH BATTERIES
HDO
10
BATTERY CARE