Photon Focus MV1-D3360-160-CL Series User Manual page 91

Cmos camera with cameralink interface
Table of Contents

Advertisement

Interface: Description of the camera interface.
Baudrate: The actual baud rate between camera and frame grabber.
For any support requests, please enclose the information provided on this panel.
Counters
The camera has the following counters.
Image: The image counter is a 24 bit real-time counter and is incremented by 1 for every new
image.
Missed Trigger: This is a counter for trigger pulses that were blocked because the trigger pulse
was received during image exposure or readout. In free-running mode it counts all pulses
received from interface trigger or from I/O trigger interface.
Missed Burst Trigger: This is a counter for burst trigger pulses that were blocked because the
burst trigger pulse was received during the last burst is not yet finished.
To update the value of the information properties, click on the Update-Button; to reset the
properties, click on the Reset-Button.
Reset Counters
This feature allows to reset the image counter and the real-time counter (timestamp) to be
reset by an external signal.
Dual: If Dual Mode is active then CounterReset can be set seperately for the image counter and
for the real time counter. In this case the settings without 'RTC' are applied to the image
counter and the settings with 'RTC' in its name are applied to the real time counter.
Mode: Reset Counters mode. It determines how often the selected source should reset the
counters. The setting Once works together with the ResetCounter.OnNextTrigger (button
OnNextTrigger).
OnNextTrigger: This property applies only to ResetCounter.Mode = Once. In this mode the
counters are reset on the next active edge of the selected reset source (property
ResetCounter.Source) after the device is armed with a click on the button OnNextTrigger.
Source: Reset counter source.
Invert The rising edge of the selected reset source is teh active trigger edge. The falling edge is
the active edge If Invert is selected.
Status Line
Enable Status Line: The status line replaces the last line of an image with image information,
please refer the manual for additional information.
8.1 MV1-D3360-160
91

Advertisement

Table of Contents
loading

Table of Contents