Table of Contents
Advertisement
User Manual – Controls and connections
4
Post-processing and Setup section: here you can find the controls to process the signal and the Setup options.
The Key Touch in this section are:
-
[EFFECT
]: Activates/deactivates (press) or set up (press
and hold) chorus and delay effects (see par.9.1).
-
[REVERB
]: activates/deactivates (press) or set up (press
and hold) the master reverberation effect (see par.9.1).
-
[EQ
]: Activates/deactivates (press) or set up (press and
hold) the master equalizer.
-
[MIXER]: Adjust sound volume and effects sends.
-
[SOUND EDIT]: Set up and adjust the sound generation
block chains (see chap. 10).
-
[FUNCTION]: General setup and file management. (see
chap. 11).
-
[SONG/DEMO]: songs player and recorder (see chap. 12).
-
[VIEW]: Multi touch panel and display setup (see chap. 5).
5
Key Touch [
]: activates/deactivates stand-by mode. Deactivating the stand-
by
function,
that
configurations (volume, sounds, levels etc.) to their previous condition (i.e.before
the instrument was set in stand-by mode).
To put the instrument on stand-by, press the [
Press the Key Touch again to turn it on.
NB
Keep in mind that in Stand-By mode, the instrument still consumes a small amount of electricity; therefore it is best to
use this function only for short periods of time.
3.2 UNDER THE KEYBOARD
Under the keyboard, on the left hand side, there is a Led and a connection panel, displayed below:
1
1
Power LED: this light turns on when the power switch (see point 7) is set as ON ( I ) and the power cable is properly
connected.
2
[LINE IN] connectors: RCA input connectors. Musical instruments or CD players can be connected to this port in
order to play through the Physis Piano speakers. When the input signal is monophonic, only use the [L/MONO]
connector.
is,
switching
on
the
] Key Touch twice.
2
instrument,
will
restore
3
4
5
EN - 6
the
6
Advertisement
Table of Contents
