Physis Piano V100 User Manual page 13

How to read the message:
-
Pedal: the rear-panel connector in which the pedal has been plugged.
-
Type: the pedal type. Switch stands for foot-switch, Potent. stands for potentiometer (expression pedal).
-
Polarity: pedal reading polarity. Can be Direct or Reverse. Polarity can be set through the "Pedals" function under
the FUNCTION menu.
Press [EXIT] or wait a short while to quit the pop-up window.
NB:
•
Pedals can be connected also while the instrument is switched on. However, do not press the pedals while
inserting the jack into the connector.
•
With all sounds not belonging to the
related functions, that might therefore differ from Soft and Sostenuto. To check or modify the pedals' functions,
first select the desired Sound, then recall the Pedals function under the FUNCTION menu. The Pedals function is
described in par. 11.6.
•
To check or modify the function assigned to the pedals connected to the [FOOT CONTROLLER] connectors,
recall the Pedals function under the FUNCTION menu (described in par. 11.6).
7
[OUTPUT] connectors: audio output connectors. Jack connectors send out a unbalanced
signal, that should be used for amplifiers or amplified speakers. If a monophonic output is
necessary, use the [L/MONO] output.
NB
•
Physis Piano generates stereophonic sounds, that is, containing spatial information, for a complete listening
experience. Using a mono connection, this information will be lost, affecting negatively the resulting sound.
Therefore, we advise against mono connections.
•
Always keep in mind to connect the devices before switching them on.
φ
PIANO family, the SOFT and SOSTENUTO pedals perform instrument-
[R]
connector
Left
speaker/diffusor
EN - 11
User Manual – Controls and connections
[L/MONO]
connector
Right
speaker/diffusor
OUTPUT
R L/MONO