Physis Piano V100 User Manual page 9

3
[USB TO HOST] Connector: USB port; connect to a computer to send and receive MIDI data..
NOTE IMPORTANTI
•
Use with an USB A/B type cable.
•
Always connect the USB cable while the instrument is switched off.
•
Exit the power saving mode on your computer before connecting the cable.
•
After connecting the [USB TO HOST] cable for the first time, Physis Piano will install its drivers on the computer.
When the process has been completed, a pop-up message will appear, to confirm that the new hardware is
ready for use.
•
When connecting a USB cable or when switching on the instrument with a connected device, always wait 5
seconds before starting any MIDI application.
4
[USB TO DEVICE] port: Connect here a USB device.
INFORMATION ON USB PENS
•
Always use USB pens formatted with FAT or FAT32 file system (no NTFS).
•
It is recommended to format USB pens with dedicated utilities, provided by the manufacturer (usually on CD-
ROM or web site).
•
If no USB pen is available when required, the following message will appear:
To access a USB pen, plug it into the [USB TO DEVICE] connector on the front panel. Then wait a short while
before trying to access it. If the pen is already connected, try disconnecting and reconnecting. Then, check that
the USB device is working and properly formatted.
User Manual – Controls and connections
[USB TO HOST]
connector
USB
connector
Computer
[USB TO DEVICE]
connector
USB device
EN - 7
TO HOST