Setting Time And Date; Pedal Settings - Physis Piano V100 User Manual

11.5 SETTING TIME AND DATE

To set time and date, select the Setup function. Place the cursor on the Time & Date field and press [ENTER].
To move the cursor, use [ ] or [ ].
Press [+] and [-] to modify the values. New values are immediately saved.
Press [ ] or [ ] to visualize other functions of the Setup menu.
Press [EXIT] to return to the FUNCTION menu.

11.6 PEDAL SETTINGS

The SOFT and SOSTENUTO pedals and the two [FOOT CONTROLLER] connected to the rear panel can be assigned
different functions. Each function can be configured. To configure one or more pedals, select the Pedals function under
the FUNCTION menu:
On the left are the rear panel connectors. To move the cursor and see the information on each connector, use [ ] or [ ].
Press [ ], to place the cursor on a connector, then [ ] or [ ] to select a parameter.
To place a cursor on a connector field, press [ ].
To modify the parameters press [+] and [-].
Parameters are:
-
Presence: cannot be modified. Shows whether a jack is plugged into a connector or not. In brackets you will find the
current position of the pedal. Check if the reading polarity is correctly set and if the pedal works properly.
Values range between 0 and 127. Potentiometer pedals can assume any value between the two, while foot-switch
pedals only have Off and Off as values.
To check if your pedal works properly, press it. The value on screen should change.
-
Type: Set the pedal type. Set Switch for foot-switch pedals, or Potent. for potentiometer (expression) pedals.
Physis Piano automatically detects the type of pedal connected to the [FOOT CONTROLLER] connector. However, you
can set manually a different pedal type. This manual setting will remain until a new pedal is connected.
-
Polarity: set the reading polarity of the pedal. To set the polarity correctly, check that if the pedal is at its minimum (or
off), the value is 0; likewise, when the pedal is at its maximum (or on), the reported value must be 127. In any case, if
you prefer, you can set polarity in the opposite manner.
-
Mode: Set the pedal mode. Pedals can be used as system pedals, therefore performing general instrument functions,
that is, not Sound-related functions. In this case, select the System option.
Pedals can also be assigned to sound-related functions, controlling parameters that affect the sound generation
regardless of the selected Sound. To do so, select the Fixed option.
Pedals can also perform specific functions, related to the selected Sound or Memory. To do so, select the Subject to
Sound option.
User Manual – Instrument general settings
EN - 39