Sharp MX-C300P Operation Manual page 75

3
Take out the new toner cartridge. Shake it vertically five or six times.
4
Insert the toner cartridge along the guides until it locks in place.
5
Press the centre of the toner cartridge until the cartridge locks into place.
6
Close the front cover.
The message will be cleared and printing will be possible.
• Even after a new toner cartridge is installed, the message may still appear, indicating that printing cannot be
Note
resumed (toner is not fed sufficiently). In this case, open and close the front cover. The machine will feed toner
again for about two minutes and then printing can be resumed.
• Before closing the front cover, make sure that the toner cartridge is correctly installed.
• When closing the front cover, gently hold both ends.
When holding the toner cartridge, do not grasp the shutter. This may
Caution
cause toner to leak.
If there is any dirt or dust on the toner cartridge, remove it before installing the
cartridge.
A toner cartridge of a different colour cannot be installed. Be sure to
Note
install a toner cartridge of the same colour.
75
TROUBLESHOOTING