Change Admin Pw; Initial Setting; Printer; Network - Sharp MX-C300P Operation Manual

Change Admin PW

Use this function to change administrator password.
To change the administrator password, see
"PROGRAMMING AN ADMINISTRATOR
PASSWORD" (p.83).

Initial Setting

The default settings for operation of the machine can
be configured. Select the [Initial Setting] to configure
the settings.
Date & Time Set
Use this to set the date and time in the machine's
built-in clock.
Daylight Saving Time
Enable daylight saving time.

Printer

Settings related to the printer function can be
configured.
Select the [Printer] to configure the settings.
Notice Page
Set whether a notice page is printed when printing
does not take place due to an error such as memory
full.

Network

Network settings are described below.
Select the [Network] key to configure the settings.
Confirmation of Network
Confirm network settings.
Connection Type
You can change the machine's network connection
type.
Wired Settings
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network,
use this setting to configure the IP address of the
machine.
The settings are shown below.
Enable DHCP
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host
Configuration Protocol). When this setting is enabled,
it is not necessary to manually enter an IP address.
IPv4 Address
Enter the IP address of the machine.
Subnetmask
Enter the Subnetmask.
Default Gateway
Enter the Default Gateway.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network,
use this setting to configure the IP address of the
machine.
The settings are shown below.
Enable IPv6 Protocol
Enable this setting.
Enable DHCPv6
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host
Configuration Protocol). When this setting is enabled,
it is not necessary to manually enter an IP address.
Manual Address
Enter the IP address of the machine.
Prefix Length
Enter the prefix length (0 to 128).
Default Gateway
Enter the IP Gateway address.
• If DHCP is used, the IP address assigned
Note
to the machine may change automatically.
If the IP address changes, printing will not
be possible.
• In an IPv6 environment, the machine can
use LPD protocol.
88
SYSTEM SETTINGS