Tray Settings - Sharp MX-C300P Operation Manual

Inserting transparency film
• Use SHARP-recommended transparency film.
• Do not touch the print side of transparency film.
• When loading multiple sheets of transparency film in the bypass tray, be sure to fan the sheets several times before
loading.
• When printing on transparency film, be sure to remove each sheet as it exits the machine. Allowing sheets to stack
in the output tray may result in curling.

TRAY SETTINGS

These programs are used to change the paper size setting of a tray, and auto tray switching.
CHANGING THE PAPER SIZE SETTING OF A TRAY
If the size of the loaded paper is different from the size shown in the display, follow the steps below to change the
paper size setting of the tray.
The paper size setting cannot be changed during printing, or when a misfeed has occurred. However, if the machine
is out of paper or out of toner, the paper size setting can be changed during printing.
See
"USEABLE PAPER" (p.13)
in the paper trays.
Press the [SPECIAL FUNCTION] key (
: Shows tray "1".
Note
: Shows tray "2".
: Shows Bypass tray.
For the paper trays and tray numbers, see "USEABLE PAPER" (p.13).
DISABLING (ENABLING) AUTO TRAY SWITCHING
When auto tray switching is enabled and paper runs out during printing, the job will continue using paper from a
different tray if that tray has the same size of paper in the same type. (This function does not operate when using the
bypass tray.)
This function has been enabled at the factory. If you prefer to disable the function, follow the steps below.
Press the [SPECIAL FUNCTION] key (
Switching" appears.
for information on the specifications for the types and sizes of paper that can be loaded
), and press the [
Press the [ ] or [
being changed. Press the [
paper size.
Press the [OK] key.
), select "Paper Size", and press the [
To re-enable auto tray switching, press the [OK] key that a checkmark
appears.
] or [ ] key to select "Paper Size Set".
] key to select the paper tray for which the paper size is
] key and press the [
19
BEFORE USING THE MACHINE
][ ] keys to select the
] key repeatedly until "Auto Tray