Table of Contents
Advertisement
TRENDnet User's Guide
Based on the schedule: The motion detection will be triggered based on the schedule
you define.
Event Configuration >> Motion Detection >> Tampering Detection
Tampering: Enable / Disable Tampering. When enabled and tampering is detected,
the camera will send video or snapshot to Email, FTP, Output device or Samba.
Event Configuration >> Motion Detection >> Record File
When an event occurs, the IP camera can record a video clip or take snapshot, and then
send the file to mail/ FTP/ Samba. Select what format you want to save.
AVI File (with Record Time Setting): Save AVI video file. The video length is according
to the value you set in Record Time Setting.
JPEG File (Single File with Interval Setting): Save single JPEG picture file when event
occurs.
JPEG Files (with Record Time Setting): Only when you select "JPEG" in streaming 1
video format of Video Setting, this option can be enabled. Select this option to save
several JPEG picture files, and the successive picture files cover a period of time
according to the value you set in Record Time Setting.
© Copyright 2017 TRENDnet. All Rights Reserved.
Event Configuration >> Motion Detection >> Record Time Setting
When an event occurs, the IP camera can record a video clip or take snapshot, and then
send to mail/ FTP/ Samba. Select the video recording length before and after event
occurs.
Event Configuration >> Motion Detection >> Network Disconnected
When enabled, the live view will be stored into the SD card if the IP Camera has no
Internet Connection (the SD card must be pre‐installed).
Event Configuration >> Motion Detection >> Network IP Check
Enter the target IP address and interval. The camera will base on the interval time to check
the target IP address. If PIN failed 4 times, the camera itself will reboot.
Limited Warranty
29
Advertisement
Table of Contents
