Table of Contents
Advertisement
TRENDnet User's Guide
5. To use Https to access camera, open your browser, and key in "https://(IP address)/"
in the address bar. Now your data will be transmitted via encrypted communications,
and the browser will check your certificate status. If it shows you a warning message.
The warning message meant that the certificate is self‐signed or signed by distrusted
institution. Click Continue to this website to view the view the camera.
Network >> Advanced >> SNMP
SNMP (Simple Network Management Protocol) provides a simple framework for
administering networked hardware. To manage the IP camera, you have to prepare a MIB
browser or similar tools first. SNMPv1, SNMPv2c, and SNMPv3 can be enabled
simultaneously.
The following examples are based on MG‐ SOFT MIB Browser. Depending on your MIS
Browser, you may see different interface and options. Please refer to the user manual of
your MIB Browser.
SNMPv1 and SNMPv2:
The term "Community name" in SNMPv1 and SNMPv2c can be roughly regarded as
key. The person who has the community name has the authority to read or edit the
information of IP camera via SNMP.
© Copyright 2017 TRENDnet. All Rights Reserved.
Click the box to enable SNMPv1 or SNMPv2c protocol, and specify the community
name for write (read and write) and read (read‐only). The user who use read
community name to access the IP camera cannot modify any data of the camera. The
community name can be any English characters and numbers, and must be shorter
than 31 bits.
SNMPv3:
For data security reason, the authentication and encryption assurances are added
when developing SNMPv3. The user has to give not only the security name (similar
with "community name" in v1&v2c) but the password in order to access the IP
camera. Please set security name, authentication type, authentication password,
encryption type, encryption password of write and read respectively. The security
Limited Warranty
17
Advertisement
Table of Contents
