Table of Contents
Advertisement
TRENDnet User's Guide
name can be any English characters and numbers, and must be shorter than 31
letters. The password must be 8~64 letters in length.
Different from in SNMPv1 and v2c, the user have to create an account when using
SNMPv3. In the account parameters, key in the security name and password you set
in the camera to get accessing.
SNMPv1/SNMPv2 Trap:
Trap is a mechanism that allows a managed device to send messages to the manager
instead of waiting passively for polling from the manager. Specify the trap event.
When those events occur, the camera will send the ring message to the Trap Address,
which is usually the manager's IP address. Trap Community means the community
that can receive the trap message.
Note: Trap Address must be under the same LAN with IP camera.
Cold Start: The camera starts up or reboots.
-
-
Setting changed: The SNMP setting is changed.
Network Disconnected: The network connection was broken down. (The camera
-
will send trap messages after the network being connected again)
V3 Authentication Failed: A SNMPv3 user account tries to get authentication but
-
failed. (Due to incorrect password or community)
© Copyright 2017 TRENDnet. All Rights Reserved.
Network >> Advanced >> IP Address Filter
You can allow or deny an IP address or even a range of the IP address to access the IP
camera. If you would like to deny a range of IP address but would allow an IP within that
range can access the camera, please setup the allow IP address in the 1
the deny range of IP address as 2
Limited Warranty
nd
priority as example below.
st
priority and set
18
Advertisement
Table of Contents
