Table of Contents
Advertisement
TRENDnet User's Guide
System >> System Information >> Time Setting
Server Time: It shows current IP camera server time.
Date Format: Select the date display format.
Time Zone: Select your time zone. It affect server time when you use "NTP" time.
Enable Daylight Saving: select the start and end daylight saving time.
NTP: Type in the IP address of the NTP server and interval time. The time of the IP
camera will be synchronized with NTP server time. To use this option, if the NTP
Server is under WAN, the IP camera must be set to access WAN ( Using the WAN IP
that provide by your ISP provider, or setup by UPnP Port Forwarding (page 18)
Synchronize with PC's time: In "Date" and "Time" column it shows your current PC
time. Click "Apply" to make the IP camera time the same with PC time. Note that IP
camera will not check with PC at every moment automatically. Every time when you
want to synchronize the IP camera time with PC time again, please select this option
and click "Apply".
Manual: Type in the date and time, and click "Apply".
System >> User Management
© Copyright 2017 TRENDnet. All Rights Reserved.
Direct Video Stream Authentication:
To stream the video directly without going through the configuration page, you can
access it via Internet.
Stream 1 Video: http://camera_ip_address:port/stream1view.htm
Stream 1 Video: http://camera_ip_address:port/stream2 view.htm
Enable Password Protection:
Yes: User needs to enter user name and password to stream the camera.
-
No: User can stream the camera without entering the username and
-
password.
-
Add user: Enter the username and password to add guest users to access the
camera. The guest user can only view the live view video and is not allowed to do any
configuration.
User List: List all users that were added into the camera. Click "Edit" to modify
the user information. Click "Remove" to remove the users from the list.
Limited Warranty
11
Advertisement
Table of Contents
