Fan Maintenance - Masport F38-NG1 Owners & Installation

MAINTENANCE
Installing Glass:
1) Install both center and side glass onto
aluminium extrusions as per diagram.
2) Place glass assembly into door frame.
3) Install retainers by placing 1 drop of glue
where previously glued and put in place.
4) Install side retainers.
5) Install door catch plate.
6) Install the 24 nuts loosely, do not tighten yet.
7) Tighten side panels nuts using the follow-
ing procedure:
a. tighten top & bottom outside corner nuts
(2)
b. tighten inside nuts (3)
c. tighten top & bottom inside corners (2)
8) Tighten the 10 nuts on center glass retain-
er.
9) Repeat step 7 for other side panel.
10) Replace new gasket by gluing it in place.
11) Install door onto stove and check the seal.

FAN MAINTENANCE

If your fan requires maintenance or replace-
ment, access to the fan is through the access
panel on the rear wall of the firebox.
If the unit is damaged or needs repair, it shall be
repaired by the manufacturer or its service
agent or similiarly qualifed person in order to
avoid a hazard.
Note: The unit MUST NOT be operated
without the fan access panel se-
curely in place and correctly
sealed.
18
IMPORTANT
Disconnect power supply
before servicing
IMPORTANT: These fans collect a
lot of dust from within your home.
Ensure you maintain these fan mo-
tors on a regular basis by vacuum-
ing out the fan squirrel cages, around
the motor, and around the grills on
the back of the stove.
WARNING: Electrical Grounding In-
structions This appliance is
equipped with a three pronged
(grounding) plug for your protec-
tion against shock hazard and
should be plugged directly into a
properly grounded three-prong re-
ceptacle. Do not cut or remove the
grounding prong from this plug.
To Remove F38-1 Fan:
1) Unplug or disconnect power source to
stove.
2) Remove all logs and the rear log support,
then remove the 10 screws holding the
access panel in place, see Diagram 1. (Fan
is also accessible by opening the right side
door. See Diagram 2).
3) Unclip the black and white wires from the
fan motor.
Diagram 1
4) Lift fan off of the 2 pins, tip back and pull
through firebox opening. Disconnect the
green ground wire from the left side of the
fan as soon as you can reach it.
Diagram 2
Replacing F38-1 Fan:
Reverse the above steps (1 - 4). If necessary
install a new gasket before replacing the fan
access panel. Make sure the fan wires and the
ground wire are reattached.
Masport F38-1 Freestanding Gas Stove