Aeration Adjustment; Log Installation - Masport F38-NG1 Owners & Installation

Freestanding gas stove
Hide thumbs Also See for F38-NG1:
Table of Contents

Advertisement

AERATION
ADJUSTMENT
The burner aeration is factory set but may need
adjusting due to either the local gas supply or
altitude.
F38-1 with 38 mj
F38-NG1
NG:
Full open
F38-LPG1
LPG: 6.4 mm open
Caution: Carbon will be produced if the air
shutter is closed too much.
Note: Any damage due to carboning re-
sulting from improperly setting the
aeration controls is NOT covered
under warranty.
Masport F38-1 Freestanding Gas Heater
LOG SET
INSTALLATION
Read the instructions below carefully
and refer to the diagrams.
broken do not use the unit until they are
replaced. Broken logs can interfere with
the pilot operation.
The gas log kit contains the following:
a) 02-65 Rear Log
b) 02-56 Middle Left Log
c) 02-44 Front Left Log
d) 02-46 Left Top Log
e ) 02-45 Front Right Log
f) 02-47 Center Log
g) 02-48 Middle Right Log
h)
Embers
i)
Lava
Note: Install Optional Brick Panels prior
to installing logs.
The "02" refer numbers (i.e. 02-65) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the embers on the left and right
sides of the firebox base.
Embers
INSTALLATION
3) Place Rear Log A)02-65 on the two pins on
the rear log support.
If logs are
902-267
902-230
902-228
902-231
Pins on Rear Log Support
902-229
902-232
902-226
902-151
902-154
4) Place the Middle Left Log B)02-56 on the
two pins as shown.
5) Place Front Left Log C)02-44 onto the 2
front pins as shown.
Embers
A)02-65
B)02-56
C)02-44
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

F38-lpg1

Table of Contents