Assembling Your Design Juicer - Gastroback Design Juicer Instructions For Use Manual

Assembling your design Juicer

Step 1:
Place the filter bowl surround on the motor block
(picture 1).
Step 2:
wARninG: Handle the units with care and
do not use any force. Pay attention to the sharp
blades on the stainless steel micro mesh filter
and the feed chute to avoid injury. Always
completely assemble your juicer before you
plug the plug into the power point.
ATTenTiOn: ensure the stainless steel filter
basket is clean before assembling. Any dehumidi-
fied left over food on the basket will block the
fine mesh holes. if necessary remove excess
fibre build up (from fruit or vegetables) accord-
ing to the instructions ´care and cleaning`.
Align the arrows on the stainless steel filter basket
with the arrows on the motor drive coupling
and push down until it clicks into place. ensure
the stainless steel filter basket is fitted securely
inside the integrated pulp container and onto
the motor base (picture 2).
Step 3:
Place the juicer cover over the stainless steel filter
on top of the filter bowl surround (picture 3). The
feed chute has to be positioned in the middle
of the filter basket and the pulp spouting of the
cover has to face away from the interlocking safety
arm.
1
2
3
36
Assembling your design Juicer
Step 4:
raise the safety locking arm straight up and lock
into the two grooves on either side of the juicer
cover. The safety locking arm should now be in
a vertical position and locked into place on top of
the juicer cover (picture 4).
iMpORTAnT: if the safety locking arm is not in
the right position the motor will not start moving.
secure the safety arm by lifting it into the two
grooves of the cover (picture 4a).
Step 5:
slide the food pusher down the feed chute by
aligning the groove of the food pusher with the
small protrusion on the inside of the top of the
feed chute. continue to slide the food pusher
down the feed chute (picture 5).
4
4a
Food
Pusher
groove
5
37