Cleaning; Adjustments; Maintenance Schedule; Pressure Washer Maintenance - Champion Power Equipment 76525 Owner's Manual & Operating Instructions

MAINTENANCE AND STORAGE

Cleaning

CAUTION
DO NOT spray engine with water.
Water can contaminate the fuel system.
Use a damp cloth to clean exterior surfaces of the engine.
Use a soft bristle brush to remove dirt and oil.
Use an air compressor (25 PSI) to clear dirt and debris
from the engine.

Adjustments

CPE recommends that you contact our service line at
1-877-338-0999 for all other service and/or adjustment
needs.

Maintenance Schedule

Follow the service intervals indicated in the schedule
below.
Service your pressure washer more frequently when
operating in adverse conditions.
Contact our help line at 1-877-338-0999 to locate the
nearest Champion Power Equipment certified service
dealer for your maintenance needs.
Every 8 hours or daily
Check oil level
Clean around air intake and muffler
Change oil
Every 50 hours or every season
Clean air filter
Change oil if operating under heavy load or in hot
environments
Every 100 hours or every season
Change oil
Clean/Adjust spark plug
Check/Adjust valve clearance*
Clean spark arrester
Clean fuel tank and filter*
Clean combustion chamber*
Replace fuel line
*To be performed by knowledgeable, experienced owners or
Champion Power Equipment certified dealers.
15
REV 76525-20140126
First 5 Hours
Every 250 hours
Every 3 years

Pressure Washer Maintenance

Make certain that the pressure washer is kept clean and
stored properly. Only operate the unit on a flat, level
surface in a clean, dry operating environment. DO NOT
expose the unit to extreme conditions, excessive dust,
dirt, moisture or corrosive vapors.
CAUTION
DO NOT use a garden hose to clean the pressure washer.
Use a damp cloth to clean exterior surfaces of the
pressure washer.
Use a soft bristle brush to remove dirt and oil.
Use an air compressor (25 PSI) to clear dirt and debris
from the pressure washer.
Inspect all air vents and cooling slots to ensure that they
are clean and unobstructed.

Cleaning Spray Nozzle

Detach the quick connect nozzle from the wand. Use a
small wire rod (paper clip) to loosen up any particles in
the quick connect nozzle and flush with water.

Storage

For short and long-term storage, please follow these
guidelines.
NOTE
Engine switch should be in the "OFF" position
while pulling the recoil cord, and performing storage
maintenance steps.

Engine Stored for less than 30 Days

1. Allow the engine to cool completely before storage.
2. Clean engine according to the Maintenance section.
3. To extend the fuel storage life add a properly
formulated fuel stabilizer to the tank.
4. Ensure the fuel valve is in the "OFF" position.
76525
ENGLISH