Distance From Cleaning Surface - Champion Power Equipment 100790 Operator's Manual

100790 - 4200 PSI PRESSURE WAShER

Distance from Cleaning Surface

The distance between the spray nozzle and the cleaning surface is another factor that affects the impact force of the water.
The impact force of the water increases as the nozzle is moved closer to the surface. You can vary the impact force by controlling
– The nozzle's fan pattern.
– The nozzle's angle to the cleaning surface.
– The nozzle's distance from the cleaning surface.
Never use a narrow high impact stream on a surface that is susceptible to damage. Avoid spraying windows with a narrow high impact
stream or turbo nozzle. Doing so may break the glass.
1. Before triggering the gun, select a nozzle with a wide fan pattern.
2. Place the nozzle approximately 4-5 ft. (1.2 m - 1.5 m) away from the cleaning surface. Then hold the nozzle at a 45 degree angle to
the cleaning surface. Trigger the gun.
3. Vary the fan pattern spray angle and the distance to the cleaning surface until optimum cleaning efficiency is achieved without
damaging the surface.
Use the following table to determine which nozzle to use.
0° 15°
Abrasive
Concrete, Brick, Masonry
Siding, Gutters, Home
Fencing, Deck, Patio
Lawn and Garden Equipment,
Boats, RVs
Recommended nozzle
NOZZLE SELECTION GUIDE
25° 40° Soap
Gentle
Use with caution
HIGH PRESSURE WASH
0° 15°
19
OPERATION
PRESSURE
25° 40°
LOW
WASH
Soap