Adjustable Unloader; Depressurize System; Operating Tips; Stopping The Engine - Champion Power Equipment 76525 Owner's Manual & Operating Instructions

76525
ENGLISH

Adjustable Unloader

The adjustable unloader, located on top of the valve, can
be turned counter clockwise (A) to decrease the PSI or
clockwise (B) to increase the PSI.
A
B
NOTE
Decreasing the PSI can be useful to prevent
damage when cleaning delicate items.

Depressurize System

To depressurize, turn engine/motor off, turn water supply
off and squeeze gun trigger 2-3 times.
WARNING
NEVER disconnect the high pressure discharge hose
from the machine while the system is pressurized.
To reduce the risk of bodily injury or property damage,
always follow this procedure whenever spraying is
stopped, when work is completed, and before checking
or repairing any part of the system.
1. Engage the trigger safety latch.
2. Turn the unit off.
3. Remove the ignition cable from the spark plug.
4. Shut off the water supply.
5. Disengage the trigger safety latch and trigger the gun
to relieve pressure.
6. Re-engage the trigger safety latch.
7. Before overnight storage, long term storage, or
transporting unit, disconnect the water supply and
turn off the fuel supply valve.

Operating Tips

CAUTION
Never operate your pressure washer without water.
CAUTION
Never connect your pressure washer to a hot water
supply.
Connecting your pressure washer to a hot water
source will significantly reduce the life of the pump
and will void the warranty.
CAUTION
Running the unit for more than one minute without
spraying water causes heat to build up in the pump.
In the event that the pump gets too hot, a thermal
relief valve will open to release the hot water.
Running the unit without spraying water can
damage pump components and will void the
warranty.

Stopping the Engine

1. Turn the Fuel Valve to the "OFF" position.
2. Let the engine run until fuel starvation has stopped
the engine. This usually takes a few minutes.
3. Press the engine switch to the "OFF" position.
4. Depressurize system.
5. Turn off and unplug all hoses. Never start or stop the
pressure washer unless the water supply is turned on.
Important: Always ensure that the Fuel Valve and the
Engine Switch are in the "OFF" position when the
engine is not in use.
NOTE
If the engine will not be used for a period of two (2)
weeks or longer, please see the Storage section for
proper engine and fuel storage.
OPERATION
12
REV 76525-20140126