California Energy Commission Battery Charging Testing Instructions - AT&T SynJ SB67108 User Manual

Appendix
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out
of the box. These instructions are intended for California Energy Commission (CEC)
compliance testing only. When the CEC battery charging testing mode is activated, all
telephone functions, except battery charging, will be disabled.
When first purchased and properly installed for charging (see Handset battery
installation and charging on pages 6-7), put the handset in the handset charger to
charge. The CEC battery charging testing mode is activated while charging.
If you have registered the handset to the SynJ SB67118/SB67138/SB67158 base, below
are the testing instructions.
To activate the CEC battery charging testing mode:
1. Press MENU�
ENTER
2. Scroll down to Registration and press
3. Scroll down to Deregistration and press
4. The telephone base screen shows Deregister all devices? <=No >=Yes.
Press SKIP. Then, the telephone base shows Deregistering.
The process takes up to 10 seconds to complete. When the phone successfully
enters the CEC battery charging testing mode, the telephone base shows
All devices deregistered. You hear a confirmation tone.
Note: When the phone fails to enter this mode, reset the system and repeat the
steps above.
To reset the system: pick up the handset and press
press
You can also reset the telephone base by unplugging the power adapter from the
telephone base and plugging it back in.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back
in. The telephone base is powered up as normal.
2. Register the handsets back to the telephone base. See pages 8-9 for handset
registration instructions.
on the telephone base in idle mode.
OFF� and place the handset back into the charger.
CLEAR
�ENTER.
MENU
�ENTER.
MENU
74
PHONE�
, then
FLASH
BC