California Energy Commission Battery Charging Testing Instructions - AT&T TL90031 User Manual

Dect 6.0 expansion handset for use with tl92151, tl96151 with bluetooth wireless technology
Hide thumbs Also See for TL90031:
Table of Contents

Advertisement

Appendix
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out
of the box. These instructions are intended for California Energy Commission (CEC)
compliance testing only. When the CEC battery charging testing mode is activated, all
telephone functions, except battery charging, will be disabled.
When first purchased and properly installed for charging (see the Battery installation
and charging section on page 7), put the handset in the handset charger to charge.
The CEC battery charging testing mode is activated while charging.
If you have registered the handset to the TL92151/TL96151 base, below are the
testing instructions.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all
cordless handsets are plugged with charged batteries and out of the chargers
before proceeding.
2. While you press and hold
adapter back to the power outlet.
3. After about 20 seconds, release
within two seconds.
(For TL92151 base, when the IN USE light starts flashing, release
/HANDSET LOCATOR and then press it again within two seconds.)
The process takes up to one minute to complete. When the phone
successfully enters the CEC battery charging testing mode, the handset
displays Put handset on BASE to register. You hear a confirmation tone.
If the phone fails to enter this mode, repeat all the steps mentioned above.
Note: The telephone base will be powered up as normal if you fail to press
/HANDSET LOCATOR within two seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back
in. The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 9-10 for handset
registration instructions.
/HANDSET LOCATOR, plug the telephone base power
/HANDSET LOCATOR and then press it again
33
BC

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tl90061Tl90041Tl90051

Table of Contents