California Energy Commission Battery Charging Testing Instructions - AT&T CL81211 User Manual

Dect 6.0 expansion handset for use with at&t models
Hide thumbs Also See for CL81211:
Table of Contents

Advertisement

Appendix
California Energy Commission battery charging testing
instructions
This telephone is set up to comply with the energy-conserving standards right out of the
box. These instructions are intended for California Energy Commission (CEC) compliance
testing only. When the CEC battery charging testing mode is activated, all telephone
functions, except battery charging, will be disabled.
When first purchased and properly installed for charging (see the Battery installation
and charging section on page 7), put the cordless handset in the handset charger to
charge. The CEC battery charging testing mode is activated while charging.
If you have registered the cordless handset to the CL81101/CL81201/CL81211/
CL81301/CL82101/CL82201/CL82251/CL82301/CL82311/CL82351/CL82401/
CL82451/CL82501/CL82551/CL82601 base, below are the testing instructions.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all
handsets are plugged with charged batteries before proceeding.
2. While you press and hold
adapter back to the power outlet.
3. After about 20 seconds, when the IN USE light starts flashing, release
/HANDSET LOCATOR and then press it again within two seconds.
The process takes one minute to complete. When the phone successfully
enters the CEC battery charging testing mode, the IN USE light turns off and all
handsets display To register, see manual.
When the phone fails to enter this mode, repeat the steps mentioned above.
Note: The telephone base will be powered up as normal if you fail to press
/HANDSET LOCATOR within 2 seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 8-9 for handset
registration instructions.
/HANDSET LOCATOR, plug the telephone base power
30
BC

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents