Table of Contents
Advertisement
Appendix
California Energy Commission battery charging testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions, except battery charging, will
be disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all cordless handsets
are plugged with charged batteries and out of the chargers before proceeding.
2. While you press and hold
the power outlet.
3. After about 20 seconds, when the IN U�E light starts flashing, release
press it again within two seconds.
The process takes up to one minute to complete. When the cordless handsets successfully
enter the CEC battery charging testing mode, the IN U�E light turns off and all handsets
display To register H�, see manual. You hear a confirmation tone.
When the cordless handsets fail to enter this mode, repeat the steps mentioned above.
Note: The telephone base will be powered up as normal if you fail to press
within two seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in. The
telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 104-105 for handset
registration instructions.
/HAND�ET LOCATOR, plug the telephone base power adapter back to
128
/HAND�ET LOCATOR and then
/HAND�ET LOCATOR
BC
Advertisement
Table of Contents
