Pitco SE Series Installation And Operation Manual page 2

THE OIL LEVEL SHOULD NOT FALL BELOW THE MINIMUM INDICATED LEVEL AT ANY
TIME. THE USE OF OLD OIL CAN BE DANGEROUS AS IT WILL HAVE A REDUCED FLASH-
POINT AND BE MORE PRONE TO SURGE BOILING.
INSTALLATION AND ALL CONNECTIONS MUST BE MADE ACCORDING TO NATIONAL
AND LOCAL REGULATIONS AND CODES IN FORCE.
A COUNTRY APPROVED ALL POLE CIRCUIT BREAKER WITH A MINIMUM OPEN CON-
TACT GAP OF 3mm MUST BE USED FOR PROPER INSTALLATION.
THE FRYER IS NOT JET STREAM APPROVED. DO NOT CLEAN THE APPLIANCE WITH A
INSTALLATION SHOULD ONLY BE DONE BY A COMPETENT SERVICE TECHNICIAN. THE
MODEL & SERIAL NUMBER, AND ELECTRICAL REQUIREMENTS STAMPED INTO THE
DATA PLATE, LOCATED ON THE INSIDE PANEL OF THE DOOR.
THIS APPLIANCE IS INTENDED FOR PROFESSIONAL USE ONLY, AND AS SUCH,
SHOULD BE OPERATED BY FULLY TRAINED PERSONNEL.
IT IS RECOMMENDED THAT THIS MACHINE BE INSPECTED BY A QUALIFIED TECHNI-
THE POWER SUPPLY MUST BE DISCONNECTED SERVICING OR CLEANING THE UNIT.
SHORTENING, WHEN IT IS AT OPERATING TEMPERATURES, IS VERY HOT AND
DANGEROUS! USE EXTREME CAUTION WHEN HANDLING! USE PROPER PROTEC-
TIVE GEAR SUCH AS INSULATED GLOVES, APRONS, FACE SHIELD, AND SLEEVES
WHEN HANDLING HOT SHORTENING. DO NOT ATTEMPT TO MOVE MACHINE THAT
HAS HOT OIL IN IT. ALLOW TO COOL TO ROOM TEMPERATURE OR DRAIN THE OIL
INTO A SUITABLE
L20-246 Rev 3 (05/12)
WARNING! FIRE HAZARD
WARNING
WARNING
WARNING
WATER JET.
NOTICE
NOTICE
NOTICE
CIAN ON A YEARLY BASIS.
WARNING
WARNING
CONTAINER BEFORE MOVING THE FRYER.